milan board - pins

[guest1302]

Hello,

At the mobo near the keyboard connector, there is a block with 8 pins.

Does someone know  what they pins are for ?

Regards,

Mark

[Arthur]

Hello Mark,

j1    PMMU Cache
j2    PMMU Cache
j3    nicht belegt (not connected)
j4    nicht belegt (not connected)
j5    VGI-Init abschalten (VGI-Init off)
j6    OEM Spezialfunktion
j7    TOS von Diskette laden (TOS load from Floppy)
j8    ROM-Monitor

I hope this helps.

Here are more infos.

http://www.der-ingo.de/en/milanhelp/hardware.html

[guest1302]

Hoi Arthur,

I know, that's jumper block J_A.

But, as you can see on the photo,  just at the right hand site of the keyboard connector, and left from 'serial 1' are 8 pins.
I didn't find any info about them.

I wonder if I could connect an Atari keyboard to the milan ?

Mark

[dbsys]

So you are talking about the 8 pins just behind the keyboard connector?

I believe these 8 pins have the same signals as on the keyboard connector.

[guest1302]

Yes,

I"m talking about the pins just behind the keyboard connector.

Mark

[Arthur]

So you are talking about the 8 pins just behind the keyboard connector?

I believe these 8 pins have the same signals as on the keyboard connector.

My thoughts exactly.

[jens]

Don't find my Milan manual and mainboard diagram atm, else I might clear that up.