atari-home.de - Foren
Hardware => Hardware (High-End) => Thema gestartet von: guest1302 am So 08.01.2012, 23:45:17
-
Hello,
At the mobo near the keyboard connector, there is a block with 8 pins.
Does someone know what they pins are for ?
Regards,
Mark
-
Hello Mark,
j1 PMMU Cache
j2 PMMU Cache
j3 nicht belegt (not connected)
j4 nicht belegt (not connected)
j5 VGI-Init abschalten (VGI-Init off)
j6 OEM Spezialfunktion
j7 TOS von Diskette laden (TOS load from Floppy)
j8 ROM-Monitor
I hope this helps.
Here are more infos.
http://www.der-ingo.de/en/milanhelp/hardware.html
-
Hoi Arthur,
I know, that's jumper block JA.
But, as you can see on the photo, just at the right hand site of the keyboard connector, and left from 'serial 1' are 8 pins.
I didn't find any info about them.
I wonder if I could connect an Atari keyboard to the milan ?
Mark
-
So you are talking about the 8 pins just behind the keyboard connector?
I believe these 8 pins have the same signals as on the keyboard connector.
-
Yes,
I"m talking about the pins just behind the keyboard connector.
Mark
-
So you are talking about the 8 pins just behind the keyboard connector?
I believe these 8 pins have the same signals as on the keyboard connector.
My thoughts exactly.
-
Don't find my Milan manual and mainboard diagram atm, else I might clear that up.