Hardware > Hardware (Classic 16-/32-Bit)

Falcon CT60

<< < (13/18) > >>

Lukas Frank:
Pavel schrieb ...
--------------------------
witeresting. According to pictures it really looks like "oveclocked" CPU. Please check the frequency of clock generated by CTCM. You can tap to "CTCM_ON" solder jumper with an oscillocsope probe.
The frequency should be 66.6MHz
If the frequency is higher, you can temporarly downclock it to 1/2 by removing the yellow jumper "CTCM/2". This should allow you to boot and re-set the clock to base value.
Then please let me understand ywhat you exactly did to the system, specifically anything that could scramble CTCM config and NVRAM. That way I can possibly help.

Back to your question: 66.6MHz is the lowest base clock CTCM can be set to. If you need to go lower from whatever reason, you can disable CTMC by removing solder blob from "CTCM_ON" jumper and putting a 5V crystal oscillator in DPI8 or DIP14 packaging over it. I would suggest going a socket route too.
------------------------
... probiere mal am Nachmittag. Habe Pavel geschrieben das ich nichts an Hardware oder Software verändert hatte.

drelius:
Ups, wie kann ich das deuten. Funktioniert der Falcon ? Muß ich mir Sorgen machen ?

Lukas Frank:
... der Atari Falcon ist zu 100% völlig in Ordnung.

Das Problem ist die CT63 ...!

Lukas Frank:
CTCM Jumper entfernt und CT60 CPX meldet unnormal 130Mhz ...

Eingestellt wieder auf 66,66Mhz und CT60 bootscreen meldet CPU = 33Mhz

... läuft jetzt so wieder und ich lasse das erstmal so.

drelius:
Dann warte ich mal ab.

Navigation

[0] Themen-Index

[#] Nächste Seite

[*] Vorherige Sete