Hardware > Hardware (Classic 16-/32-Bit)
ST im ATX Format
Lynxman:
Platinen unterwegs.
Ich habe noch ein paar übrig, also wenn noch jemand will, bitte per PN melden.
Arthur:
--- Zitat von: Lynxman am So 21.05.2023, 00:50:31 ---Platinen unterwegs.
--- Ende Zitat ---
Danke Bernd, Geld ist raus.
Lynxman:
Mahlzeit!
@tin
@Arthur
@VierAtari
Sorry Leute, mir ist eben aufgefallen das ich aus versehen die Version V1.2 des ISA Cartridge Adapter Boards habe fertigen lassen.
Zitat von hier kicken zur Seite von ChilliChai
--- Zitat ---Testing has confirmed that this version works. FMC-II RTC clock and cartridge both work fine. However testing of this version identified that GND was routed through the ISA slot to the Dallas chip so I moved to version 1.3 below with this fixed so that when you remove the ISA Cartridge Adapter card from the ISA socket that the clock keeps going. Also, testing showed that you need a voltage on the mATX board greater that 4.8v for the cartridge socket ROM3 pin to work correctly through the RTC pins CEI/CEO. If you have this version of the board, I recommend adding a bodge wire between the battery GND pin and pin 8 on the RTC Dallas socket/chip.
--- Ende Zitat ---
Die Uhr läuft bei der V1.2 nicht weiter wenn man die Karte aus dem Mainboard rauszieht.
Um das zu verhindern muss man nur eine Verbindung zwischen Ground der Batterie und Pin 8 der RTC herstellen.
Arthur:
--- Zitat von: Lynxman am So 21.05.2023, 11:45:07 ---Mahlzeit!
@tin
@Arthur
@VierAtari
Sorry Leute, mir ist eben aufgefallen das ich aus versehen die Version V1.2 des ISA Cartridge Adapter Boards habe fertigen lassen.
Zitat von hier kicken zur Seite von ChilliChai
--- Zitat ---Testing has confirmed that this version works. FMC-II RTC clock and cartridge both work fine. However testing of this version identified that GND was routed through the ISA slot to the Dallas chip so I moved to version 1.3 below with this fixed so that when you remove the ISA Cartridge Adapter card from the ISA socket that the clock keeps going. Also, testing showed that you need a voltage on the mATX board greater that 4.8v for the cartridge socket ROM3 pin to work correctly through the RTC pins CEI/CEO. If you have this version of the board, I recommend adding a bodge wire between the battery GND pin and pin 8 on the RTC Dallas socket/chip.
--- Ende Zitat ---
Die Uhr läuft bei der V1.2 nicht weiter wenn man die Karte aus dem Mainboard rauszieht.
Um das zu verhindern muss man nur eine Verbindung zwischen Ground der Batterie und Pin 8 der RTC herstellen.
--- Ende Zitat ---
Ist doch toll... dann gibt es was zu tun. :D
VierAtari:
Na ja ist ja nicht schlimm. Wo kann man übrigens die BOM der Karten sehen, finden? Bin auf der Suche was für Teile überhaupt benötigt werden kann aber nichts finden.
Navigation
[0] Themen-Index
[#] Nächste Seite
[*] Vorherige Sete
Zur normalen Ansicht wechseln