0 Mitglieder und 1 Gast betrachten dieses Thema.
Jumper Konfiguration S2----------------------- OPEN CLOSED OFF ON +----+ |xx |1 Always OFF |xx |2 Start Enable | xx|3 Parity Check A2|xx |4 A1|xx |5 A0|xx |6 +----+ SW1 SCSI ID ------- +----------+-----------------------+ | SCSI ID | Jumpers | | | A2 | A1 | A0 | +----------+-------+-------+-------+ | 0 | OPEN | OPEN | OPEN | +----------+-------+-------+-------+ | 1 | OPEN | OPEN | CLOSED| +----------+-------+-------+-------+ | 2 | OPEN | CLOSED| OPEN | +----------+-------+-------+-------+ | 3 | OPEN | CLOSED| CLOSED| +----------+-------+-------+-------+ | 4 | CLOSED| OPEN | OPEN | +----------+-------+-------+-------+ | 5 | CLOSED| OPEN | CLOSED| +----------+-------+-------+-------+ | 6 | CLOSED| CLOSED| OPEN | +----------+-------+-------+-------+ | 7 | CLOSED| CLOSED| CLOSED| +----------+-------+-------+-------+ SW1-3 CLOSED Parity check enabled OPEN Parity check disabled SW1-2 OPEN Spindle Motor starts by Power On CLOSED Spindle Motor starts after SCSI command2 TerminatorsRead more: http://stason.org/TULARC/pc/hard-drives-hdd/nec/DSE-2100S-S5D-2100MB-3-5-SL-SCSI2-FAST.html#.UMGJH6zNmSr#ixzz2ENFwub00
Versuche es mal über einen anderen Hostadapter als den vom MegaSTE, oder noch besser, wenn du hast, ein PC mit SCSI-Hostadapter, um die Funktionalität der Platte zu testen.